Operation Manual

8
ENGLISH
CLEANING AND CARE
----------------------------------------------------------------------------
Cleaning with the brush
1 Use the button to switch off
the appliance.
2 To remove the foil frame, press
on one of the side catches
with your thumb to lift up this
side of the foil frame.
Then press the second catch on
the other side and lift up the foil
frame.
3 Remove the blade blocks for
cleaning by pulling them up-
wards off the oscillator .
4 Carefully brush hair clippings
out of the blade blocks, the foils
and the housing.
Caution
7
The foils can be irreparably
damaged during cleaning. Do
not press on the foils.
5 Put all parts on again after
cleaning.
Caution
7
To ensure smooth operation, the
foils must sit exactly in the foil
frame and this must be inserted
exactly in the housing. During
cleaning, the foils remain in the
foil frame. Only release the foils
from the frame when they are
replaced.
F
E
D
H
Replacing the cutting foils
and blade blocks
You can replace the cutting foils
and the blade blocks. The appro-
priate replacement shaving system
(containing two blade blocks and
one foil frame) is article number
MSR 58. Ask your specialist
dealer about it.
Replacing the cutting foils
1
Use the button to switch off
the device.
2 To remove the foil frame, press
on one of the side catches
with your thumb to lift up this
side of the foil frame.
Then press the second catch on
the other side and lift up the foil
frame.
3 Fix the foil frame with the new
cutting foils in the housing.
Caution
7
Ensure that the foil frame is
firmly in position and cannot
move within the housing.
D
H