Operation Manual

25
ENGLISH
Antennas
1 For FM stations (VHF) extend the telescopic antenna.
Note:
7
If the FM signal is too strong, it is advisable to push
in the telescopic antenna.
2 The radio recorder has a built-in rod antenna for
MW reception. Turn the radio recorder about its own
axis to point the antenna.
Selecting the radio input source
1 Move the »OFF CD USB RADIO« switch to the
»RADIO« position.
Setting and storing radio stations
Automatic station search
1 Select the frequency band (FM or MW) using
»■/BAND«.
2 Activate the station search by pressing
»PROG/MEM« until the frequency display
changes to rapid run-through.
– The device searches for up to 10 radio stations
and then saves them. After the search has
finished, the station stored in position 01 can be
heard.
Automatic station search
1 Select the frequency band (FM or MW) using
»■/BAND«.
2 Activate the station search by pressing »DOWN «
or »UP « until the frequency display changes to
rapid run-through.
– The search stops when a programme is found.
Manual station search
1 To move the frequency forward in steps, briefly press
»DOWN « or »UP « several times.
– The frequency changes in steps of 50 kHz.
RADIO MODE _________________________________________________________
Storing stations on station positions
Up to 10 stations in the FM band and up to 10 stations
in the MW band can be stored.
1 Select the frequency band (FM or MW) using
»■/BAND«.
2 Press »DOWN « or »UP « to select the station.
3 Press »PROG/MEM« briefly to activate the memory
function.
4 Select the desired station position with
»ALBUM MEMORY UP« or
»ALBUM MEMORY DOWN«.
5 Press »PROG/MEM« to save the station.
6 To store more stations, repeat steps 2 to 5.
Note:
7
You can replace a station on a preset with a new
one by carrying out steps 2 to 5 as described
above.
Selecting a preset position
1 Select the frequency band (FM or MW) using
»■ /BAND«.
2 Select the station preset position with »ALBUM ME-
MORY UP« or »ALBUM MEMORY DOWN«.
Stereo/mono reception
If the device receives an FM stereo station, ») « ap-
pears in the display. However, if the signal from the FM
stereo station is weak, you can improve the sound qual-
ity by switching to mono reception.
1 Slide »FM MODE MONO/STEREO« to switch to
mono.
2 Slide »FM MODE MONO/STEREO« to switch to
stereo.