Operation Manual

19
ENGLISH
POWER SUPPLY
----------------------------------------------------------------------------------------
Mains operation
Note:
7
Check that the mains voltage on the
type plate (on the bottom of the device)
corresponds to your local mains supply. If
this is not the case, contact your specialist
dealer.
1 Plug the mains cable supplied into the
»AC
~
« socket on the back of the device.
2 Plug the power cord into the wall socket.
Caution:
7
The device is connected to the mains with
the power plug. To fully disconnect the de-
vice from the mains, pull out the plug.
7
The mains plug is used to disconnect the
device. It shall remain readily operable
and should not be obstructed during in-
tended use.
Battery operation
1 Open the battery compartment on the bot-
tom of the device by pressing the mark and
removing the lid.
2 Insert six batteries (6 x 1.5 V, type
IEC R20/UM1/D size), observing the
polarity marked on the lid of the battery
compartment.
3 Close the battery compartment.
Notes:
7
Do not expose the batteries to extreme
heat, caused for example by direct sunlight,
heaters or fire.
7
Remove the batteries when they are flat or
when you know that the device will not be
used for a long period of time.
7
The manufacturer accepts no liability for
damage resulting from leaking batteries.
7
The batteries are switched off during mains
operation.
Environmental note:
7
Batteries, including those which contain no
heavy metals, may not be disposed of with
household waste. Please dispose of used
batteries in an environmentally responsible
manner. Find out about the legal regula-
tions which apply in your area.