CLOCK RADIO Sonoclock 590 Sonoclock 590 Q EN
ENGLISH 2
___________________________________________________________ ALARM TIME SLEEP SNOOZE UP AL 1 1+2 2 - TUNING + FM MW 3 ENGLISH U + VOLUME - DOWN RADIO ON
___________________________________________________________ ENGLISH 4 ENGLISH 05 -13
SAFETY AND SET-UP_____________________________ 7 This device is designed for the 7 playback of audio signals. Any other use is expressly prohibited. 7 7 Do not place any naked flames such as candles on the device. 7 Make sure the device is adequa- tely ventilated. Do not cover the ventilation slots with newspapers, table cloths, curtains, etc. 7 ry to extreme heat, caused for example by direct sunlight, heaters or fire. Protect the device from moisture (water drops or splashes).
OVERVIEW_______________________________________ See the figure on page 3. Controls on the top SLEEP Activates the sleep timer. To display the current sleep timer setting. UP To set the clock and alarm time with the time running quickly forwards. TIME Press and hold down: to set the time. DOWN To set the clock and alarm time with the time running slowly backwards. ALARM Press and hold down: to set the alarm time. Press briefly: to display the alarm time. SNOOZE Interrupts the alarm function.
OVERVIEW_______________________________________ Controls on the right side + VOLUME - Adjusts the volume. AL 1 1+2 2 Sliding switch, switches between alarm time 1 or 2; activates alarm time 1 or 2 or 1+2. U Headphone jack for connecting a stereo headphone set with a jack plug (3.5 mm). The loudspeaker of the device is automatically switched off. Controls on the back Ü Mains cable. Wire antenna for FM reception. The device has a built-in antenna for MW reception.
POWER SUPPLY_ ________________________________ Mains operation Check that the mains voltage on the type plate (on the bottom of the device) corresponds to your local mains supply. If this is not the case, contact your specialist dealer. 1 Plug the mains cable into the socket (230V~, 50 Hz Sonoclock 590, 230V~, 50/60 Hz Sonoclock 590 Q). Caution: 7 T he device is connected to the mains with the power plug. To fully disconnect the device from the mains, pull out the plug.
SETTINGS_________________________________________ Setting the clock When you switch on the device for the first time, the time flashes in the display to indicate that you must set the clock. The same thing applies after a power failure, or if the device has been plugged out and no backup battery is inserted. The time at Sonoclock 590 will be synchronized by the mains frequency and for the Sonoclock 590Q it is controlled by an integrated quartz crystal. 1 Press and hold down »TIME«.
OPERATION______________________________________ Switching on and off 1 Press »RADIO ON« to switch on the device. 2 Press » « to switch off (stand-by) the device. Radio operation For the best FM (VHF) reception, it is sufficient to direct the wire antenna accordingly. Tuning radio stations 1 Set the frequency band with »FM MW«. 2 Find and tune the station using »- TUNING +«. Adjusting the volume 1 Adjust the volume using »+ VOLUME -«.
OPERATION______________________________________ Alarm with radio station 1 Press »RADIO ON« to switch on the device. 2 Set the frequency band with »FM MW«. 3 Find and tune the station using the »- TUNING +«. 4 Set the required alarm volume with »- VOLUME +«. 5 Select the radio alarm (» « ) with » «. – The device switches the radio on at the set times (alarm duration 59 minutes). Alarm with signal tone 1 Set the signal alarm (» « ) with » «.
OPERATION______________________________________ Sleep timer mode The device possesses a sleep timer, which switches it off in radio mode at a preset time. It is possible to set the switch-off time for between 0 minute (off) and 59 minutes. Setting the sleep timer 1 Press »SLEEP« to switch on the device. – Display: The switch-off time »0:59« (59 minutes). – You will hear the selected radio station. 2 To set the required switch-off time press »SLEEP« and hold it down.
INFORMATION__________________________________ Environmental note Technical data This product has been manufactured with high quality parts and materials which can be reused and are suitable for recycling. This device is noisesuppressed according to the applicable EU directives. This product fulfils the European directives 2004/108/EC, 2006/95/EC, 2009/125/EC and 2011/65/EU. Therefore, do not dispose the product and battery with normal domestic waste at the end of its service life.
Grundig Intermedia GmbH Beuthener Strasse 41 D–90471 Nürnberg www.grundig.