Operation Manual

ENGLISH
21
Setting time and day of the
week
If the device has been switched on
for the first time – if no time signal
has been received – »0:00« appears
in the display as a sign that the time
has to be set. The same applies after
a power failure or if the device has
been disconnected from the mains
supply and no back-up battery has
been inserted.
1 Press »SET«.
– Display: »:« flashes.
2 Press »HOUR/VOL+« briefly to
set the hours step-by-step or hold
down to run through the hours
continuously.
3 Press »MIN/VOL-« briefly to set
the minutes step-by-step or hold
down to run through the minutes
continuously.
Notes:
7
When the minute display chang-
es from »59« to »00«, this does
not affect the hour display.
7
The device saves the set time
automatically after 10 seconds.
4 To set the day of the week, press
»TIME ZONE/WEC« and »SET«
at the same time.
– Display: for example, the day of
the week »1« = Monday.
SETTINGS ________________________________________
5 Set the day of the week (»1« =
Monday, »2«, »3«, »4«, »5«, »6«
or »7« = Sunday) using »HOUR/
VOL+« or »MIN/VOL-«.
– The device saves the selected
day of the week automatically
after 5 seconds.
Note:
7
Display the selected day of the
week and press »SNOOZE«
longer than 3 seconds and hold
it pressed.
Setting the time zone
If you use the device outside of the
Central European Time Zone (CET),
you can correct the time by +/– 2
hours.
1 Press »TIME ZONE/WEC« keep
pressed for approximately 2 se-
conds.
– Display: »00«, »:« flashes.
2 Set the time zone with »HOUR/
VOL+« or »MIN/VOL-« (Scale:
»00«, »01«, »02«, »-02« and »-01«).
– Display: e.g. »02«.