SC 910 page 1 SONOCLOCK SC 910
SC 910 page 2 INDEX Additional information for units sold in Great Britain: Units sold in GB are suitable for operation from a 240 V AC, 50/60 Hz mains supply. Mains plug This apparatus is fitted with an approved moulded 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 AMP, A.S.T.A. or BSI approved type. 3 Refit the fuse cover.
SC 910 page 3 ɷ 23.15:30 љ AL 6.15 ʍ FM IIII SONOCLOCK 910 PRESET ALARM AL.
SC 910 page 11 Radio controlled clock Radio controlled clock With your built-in radio controlled clock, you are in the possesion of an absolutely precise alarm- and appointment clock which sets itself fully automatically to the radio-transmitted time signal of the most accurate clock in the world: the atomic clock of the Bundesanstalt (Federal Standards Institute) in Braunschweig/Germany (PTB). The time deviation is smaller than 1 second in 1 million years.
SC 910 page 12 Operating Instructions Clock synchronization When the clock has been connected, the time display shows: GB The '00' indication flashes every second as soon as the seconds clock frequency runs synchroniously with the time signal and normalfrequency transmitter DCF77 in Mainflingen. -- --:00 --- --- If this is not the case after a few seconds, the signal strength is poor or there are signal-interferences.
SC 910 page 13 Operating Instructions Radio Reception • Switch the set on with the +/- or PRESET buttons. – You will receive the last heard station (e.g. FM II) with the volume level last set. • Press the SNOOZE button to switch the radio off. GB Programming/Calling up the FM Presets You can store in memory up to 8 FM stations. These are positioned in two levels. The first level with 4 preset stations is indicated by FM I - FM IIII symbolisiert.
SC 910 page 14 Operating Instructions Setting the wake-up time GB • Press and hold the ALARM button and set the desired wake-up time with the +/- buttons. – When the +/- buttons are kept pressed down, the wake-up time will be set first with slow then with high speed. ɷ – 4 seconds after having released the respective button, the display ʍ returns to indication of the day and date. 18.30:58 AL 6.30 • To check the set wake-up time, briefly press the ALARM button.
SC 910 page 15 Operating Instructions Wake-up At the set time, the set is switched on with the desired function. Interrupting and repeating the wake-up function • A short pressure on the SNOOZE button on the top of the set interrupts each wake-up mode and the sleep symbol љ flashes. After 10 minutes, the wake-up function is recovered. This function can be repeated (within the switch-on period of 60 minutes).
SC 910 page 16 Operating Instructions Setting the time zone GB The time signal transmitter DCF 77 transmits the time valid in middle-europe, or the Daylight Saving Time of middle-europe. When using your SONOCLOCK 910 in another time zone or to indicate a local time in another time zone, you can set the respective time difference as follows: • Press and hold first the SNOOZE button and press then also the SLEEP button longer as 5 seconds. – The date indication disappears and e.g.
SC 910 page 17 Operating Instructions Serial output This set is provided with a serial data output (Cinch (phono) socket DATA OUT behind flap on back of set) for exact clock synchronization of PC’s or computer networks.
SC 910 page 74 GRUNDIG AUDIO INTERNACIONAL 0 4701 BRAGA 0 PORTUGAL 23456789 72010-746.
