Operation Manual

10
ENGLISH
Cleaning cyclone assembly
and dust container
1 Empty the dust container
A
if it is filled
with dirt.
2 Open the dust container cover
C
by
turning it counterclockwise. Remove the
cyclone assembly
V
, foam filter
T
and
motor protection filter
U
.
3 Wash the cyclone assembly
V
in warm
water, if required, and wait until the
cyclone group is dry.
4 Clean the dust container
A
with a damp
cloth, if necessary.
5 Wash the filter in warm water.
6 Lightly tap across the filter to remove
excessive water. Repeat this and wait until
it is dried by itself. Do not use any heating
device for drying.
7 Make sure that all components are
completely dried before installing all
components to the appliance and
switching on the appliance.
8 Replace the cyclone assembly
V
, foam
filter
T
and motor protection filter
U
in
their places and close the upper cover
C
so that it is seated with a click.
INFORMATION ______________________________
Cleaning and maintenance
■ Before cleaning, unplug the appliance from
mains and let the vacuum cleaner to cool
down completely.
■ Do not immerse the vacuum cleaner in water
or in any other liquid. Ensure that no liquid
gets inside the appliance during cleaning.
■ Components may be cleaned as follows:
Cleaning the dust container
1 The dust inside the dust container should be
emptied when it reaches Max level.
2 Press the dust container release button
E
to
remove the dust container
A
by holding from
the dust container handle
B
.
3 Press dust quick release button
S
over a
dustbin, for emptying the dust container
A
.