Operation Manual

ķ
20
4 Autom. LEARN (radio mode)
If you are in a reception area in which
reception of RDS programmes with traffic
announcements is poor, you can disable
the "Autom. LEARN (LRN) in radio mode"
function.
"LRN ON": autom. LEARN
"LRN OFF": no autom. LEARN for volume set-
tings greater than "VOL 4".
5 Autom. change of regional programme
If an RDS programme consists of various
regional programmes, it may occur that
your car radio changes between regional
stations when changing the reception area.
"REG ON" autom. change of regional
programme is possible.
"REG OFF" no change of regional
programme is possible.
6 Switching on and off with the
ignition/start switch
"IGN ON" It is possible to switch the radio on
and off with the ignition/start
switch of the vehicle.
"IGN OFF" Switching on and off is only possi-
ble with the
“
IO
POWER
button.
7 CD or AUX input sensitivity
Adapting a CD changer of an AUX audio
programme source.
"MCD LOW" low
"MCD MID" median
"MCD HIGH" high (e.g. MCD 30)
8 Volume limitation when switching on
"ON VOL - -": no limitation or
"ON VOL 20": max. volume, e.g. 20
(- - … 40).
The volume is limited only if the volume
when the car radio is switched off is
greater than the set value!
9 Minimum volume for traffic
announcements
"TA VOL 16" (10 … 40)
You hear the set volume while making the
setting.
ßI Speed-controlled volume
"SCVOL 124" (- - … 144)
Setting is only possible if a speed-control-
led signal is present on the SCV connection
(A1).
" SCVOL - - " : SCV switched off.
" SCVOL 144 " : maximum effect.
Setting
1. Car standing still, motor running:
set desired volume with
¢¢
rotary knob.
2. Prepare EXPERT setting:
press the
“
LOUD
EXPERT
button until signal
sounds.
Turn
¢¢
rotary knob until e.g.
" SCVOL ..." appears in the display.
Briefly press the
“
LOUD
EXPERT
button:
»
E « appears in the display.
3. At higher speed:
use the
¢¢
rotary knob to set the required
volume, e.g." SCVOL 124 " in display.
Press the
“
LOUD
EXPERT
button until the signal
sounds.
í
For reasons of safety the following
setting should be carried out by the
passenger!
EXPERT