Users Manual

Power Off

GRYPHON™ I GBT/GM4200

Link Scanner as HID device to a Bluetooth host

Use this procedure to send data to a Bluetooth host using

the Bluetooth HID profile.

1. If using a Bluetooth adapter on the host device,

install any driver provided with the adapter.

2. Scan the Link to Host in HID mode label below to

make the scanner visible to the host device.

3. Use the Bluetooth manager of the host device to

"Discover new devices" and select "GBT4200 …". If

you receive an error message, it may be necessary

to change the security settings on either the host

device or the scanner.

4. On the host device, open the program that is meant

to receive the incoming data.

The data transmitted by the scanner will appear in the

program as if it was typed using the keyboard of the host

device.

Link to Host in HID mode

POWER OFF

Scan the bar code below to shut off power to the hand-

held until the next trigger pull.

Power Off

NOTE: The Gryphon I GBT4200 can be set up to

authenticate the remote system when connecting,

by entering a Bluetooth passkey or a PIN code. If

you want to set the security level and authentica-

tion options suitable for your application, or when

adding new equipment to a system that requires

authentication or uses a custom security PIN,

please see the PRG for information.