User's Guide

12
B-50KR User Guide
STEP 3. Run the Outside Antenna Cable
When mounting the outside antenna to the outside wall of your building, the easiest way is
to run the cable on the outside of the wall and attach it to the exterior of your oflce & building.
Then drill a hole through the wall which will allow the cable to appear on the inside of the
building. To avoid any potential harm or damage, make sure that there are no electrical outlets,
sewer water pipes, or electrical wiring in the wall before drilling.
Note TV cables already being used for other purposes can not be shared with the cell
booster during installation.
After drilling the required hole, run the cable through and seal it.
In some instances, it may be possible to run the cable up into the fascia of the attic overhang.
In this circumstance, the cable will be accessible in the attic further routing.
Outside Antenna
to 2 ft. cable
To Lightning Protector
To Outside Antenna
Cable (100 ft.)