User's Manual

Version 1.0



September 2010

Bracket Sems Screw

M6 x 16 mm

Ground Sems Screw

M4 x 8 mm

Ground lug detail drawing

To approved ground source

<Figure 3> Hanging and Grounding

the Repeater

Hanging and Grounding

1. Hang the Repeater from the mounting bracket.

2. Locate the four Bracket Sems Screws with installed washers. Tighten bolts until secure.

3. Locate the ground lug on the underside(or side) of the repeater.

4. Crimp the ground cable to the ground lug.

5. Route the free end of the ground cable to an approved(per local code or practice) ground source.

CAUTION

Ground cable must be properly grounded to provide both EMI and voltage surge protection for the repeater.