User's Manual

FCC ID : U88GSTR1930DT-SPR
HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD.
SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA
TEL:[phone] FAX:[phone] www.hct.co.kr
22
When in
alarming
* Temperature alarm
* Please Check following status
- Setting level of maximum temperature limit
- Temperature offset is normal or not.
- Circumstance temperature.
* Please reset AC power upon complete Alarm trouble shooting
When in
alarming
* DL low-input alarm
* Please reset AC power upon complete Alarm trouble shooting
When in
alarming
* DL low-output alarm
* Please Check following status
- Output power level is normal or not.
- Whether minimum output limit level is normal.
* Please reset AC power upon complete Alarm trouble shooting
When in
alarming
* RF OFF
* Please reset AC power upon complete Alarm trouble shooting
When output
power is no
longer strong
or problem
* Technician should verify
category of alarm at the front
side of repeater.
* When Red light on the Shutdown LED, technician should
troubleshoot the alarm via Notebook computer.
Same as above * Technician should connect
antenna with output port of
repeater.
* Please make sure all
connectors are fastened
* Reconnect the connector.
* Please change it if the connector is detective.
Same as above * Check the input level not to
be too low.
* Increase output power or check input change of BTS side.
Same as above
* Check Gain of the unit
* If the Gain is different from normal level, please contact A/S
team.
Same as above * Cable loose or over loss. * Please contact installer or service provider upon verification.
Report No. : HCT-R07-013 22/33