Product Specs

Hui Zhou Gaoshengda Technology Co., LTD DCT85N2001

PAGE 5 OF 4

Version 1.

１) Une antenne pifa dont le gain ne dépasse pas 2 DBI doit être utilisée pour 2,4 G et

une antenne pifa dont le gain ne dépasse pas 3 DBI doit être utilisée pour 5 G.

２) doivent être installés de façon que l'utilisateur final ne peut pas modifier l'antenne

３) La ligne d’alimentation doit être conçue en 50ohm

Le réglage précis de la perte de rendement, etc. peut être effectué en utilisant un réseau

correspondant.

Detachable Antenna:

BLE

Antenna 1: PIFA antenna & 2 dBi

Detachable Antennas:

2.4G

Antenna 1: PIFA antenna & 2 dBi

Antenna 1: PIFA antenna & 3 dBi

Antenna 2: PIFA antenna & 2 dBi

Antenna 2: PIFA antenna & 3 dBi

Notice to OEM integrator

Must use the device only in host devices that meet the FCC/ISED RF exposure category of mobile, which means the

device is installed and used at distances of at least 20cm from persons.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the transmitter as

show in this manual(FCC/ICanada statement).

According to FCC Part 15 Subpart C Section 15.212, the radio elements of the modular transmitter must have the

radio frequency circuitry shielded. However, due to there is no shielded for this Module, this module is granted as a

Limited Modular Approval. When this Module is installed into the end product, a Class II Permissive Change or a

New FCC ID submission is required to ensure the full compliance of FCC relevant requirements.

Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for the transmitter

when the module is installed in the host.

The use condition limitations extend to professional users, then instructions must state that this information also

extends to the host manufacturer’s instruction manual.

This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting

condition or different operational conditions for a stand-alone modular transmitter in a host, host manufacturer

have to consult with module manufacturer for the installation method in end system.

Any company of the host device which install this modular should perform the test of radiated &

condicted emission and spurious emission etc. according to FCC Part 15C: 15.247 and 15.209 &

15.207, 15B class B requirement, only if the test result comply with FCC part 15C: 15.247 and

15.209 & 15.207, 15B class B requirement. Then the host can be sold legally.

This modular transmitter is only FCC authorized for the specific rule parts ( 47CFR Part 15.247

and 15.407) listed on the grant, and that the host product manufacturer is responsible for

compliance to any other FCC rules that apply to the host not covered by the modular transmitter

grant of certification.

Host manufacturer is strongly recommended to confirm compliance with FCC/ISED

requirements for the transmitter when the module is installed in the host.

Must have on the host device a label showing Contains FCC ID:2AC23-DCT85 and IC:12290A- DCT85

Installer should put it in the manual：