Product Specs

Hui Zhou Gaoshengda Technology Co., LTD W2GM2500T
PAGE 3 OF 3
Version 1.0
a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: 2AC23-W2GT Or Contains FCC ID: 2AC23-W2GT”.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment
- Information on test modes and additional testing requirements
Any final host product with the modular transmitter installed should be under test according
to guidance given in KDB 996369 D04. To enter test mode for module,
MP_Kit_RTL11ac_8822BU_USB_v5.01 software and command is necessary. When something wrong happens
in configuring test modes for host product with module, host product manufacturer should
coordinate with module manufacturer for technical support. It is recommended that some
investigative measurements should be taken to confirm that host product with module installed
does not exceed the spurious emissions limits or band edge limits.
- Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247)
list on the grant, and that the host product manufacturer is responsible for compliance to any
other FCC rules that apply to the host not covered by the modular transmitter grant of
certification. The final host product still requires Part 15 Subpart B compliance testing with
the modular transmitter installed when contains digital circuity.
Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102
and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure
and compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de
RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information
canadienne sur l'exposition et la conformité de rf.