User's Manual

2 Installation
Topics Covered in this Chapter
▪ Mounting the Antenna
▪ EDGE GSF LFID W/ AUTO TUNING Connections
Mounting the Antenna
The EDGE GSF LFID with Auto Tuning must be installed to the stall before connecting it to the EDGE
GSF Feeder.
What You Should Know
These instructions only cover the installation of the EDGE GSF LFID with Auto Tuning to the GSF stalls.
Refer to the GSF Stall assembly and installation manual for details on stall installation. See figure below
for all references to hardware and parts listed in steps.
1. Align the four holes on the back of the antenna (06) with the four holes in the antenna plate (01).
2. Attach the antenna (06) to the antenna plate (01) by installing the bolts (10) through the holes in the
back of the antenna plate (01) and into the antenna (06).
3. Mount the antenna plate supports (04), bottom reinforcement bracket (05), and the antenna plate
(01) using hex bolts (07), washers (08), and nuts (09), do not fully tighten hardware.
4. Install the top antenna reinforcement bracket (03) to the antenna plate (01) and antenna upper plate
(02) using hex bolts (07), washers (08), and nuts (09), do not fully tighten hardware.
5. Install the bottom antenna reinforcement bracket (03) to the antenna plate (01) and bottom antenna
reinforcement bracket (05) using hex bolts (07), washers (08), and nuts (09), do not fully tighten
hardware.
6. Position the antenna assembly between the sides of the stall and install the antenna assembly to
the sides using the hex bolts (07), washers (08), and nuts (09).
• If assembling only one stall, install the hardware and fully tighten.
• If assembling multiple stalls side by side, pre-assemble the antenna, antenna plates, and sup-
ports for all the stalls. Then position the antenna assemblies between the stall sides and install
the hardware through the two antenna assemblies that share the stall side.
890-00682 EDGE GSF LFID W/ AUTO TUNING
13