User's Manual
Table Of Contents
- Installation / User Manual
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Maintenance
- Chapter 4 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Safety Characteristics and Certification
- Appendix C EC Declaration of Conformity
- Appendix D Innovation, Science and Economic Development Canada Statement
- Appendix E FCC part 15 statement
- Appendix F FCC RF Exposure
- Appendix G FDA declaration
- Appendix H Reduction of Hazardous Substances
- Appendix I Disposal and Recycling Information
- Appendix J California Proposition 65
- Appendix K Product material composition
- Appendix L Packaging Characteristics
- Appendix M EDGE GSF LFID with Auto Tuning - End-of-Life Disassembly
4 Troubleshooting
Table 4-1 Troubleshooting
Problem Possible Solutions
EDGE GSF does not
power up
Verify if the AC power cable plug is connected in the outlet
Verify if the outlet breaker is not opened or correctly sized
Ensure that the AC power cable plug is not disconnected in the EDGE GSF plastic
enclosure
Verify if the outlet provides a voltage from 100-Vac to 240Vac
Verify if the power led is green on the user interface
If the problem persists, contact AP or GSI Electronics
EDGE GSF LFID W/
AUTO TUNING does
not work
Verify if the EDGE GSF LFID W/ AUTO TUNING cable connector is properly con-
nected in the EDGE GSF LFID W/ AUTO TUNING connector
Verify if the EDGE GSF LFID W/ AUTO TUNING cable terminal is properly connected
on the PCB-452
If the problem persists, contact AP or GSI Electronics
890-00682 EDGE GSF LFID W/ AUTO TUNING
19