PARTY SPEAKER Manual M1
INTRODUCTION 1 4 2 5 3 6 7 14 15 8 9 10 11 12 13 1 Button: Short press previous track. 2 Button: Short press Pause/Play.Long press disconnect current bluetooth. REC Button:Long press to play the recording file in the U disk / TF mode.short 3 press to record in the U disk / TF Card mode with the microphone inserted. 4 Button: Short press to play next track. M/Light Button: Short press to switch mode. 5 Long press Turn on/Off Dazzle lamp.
9 TF Card slot: Insert TF Card to play music. 10 Power switch: Power ON/OFF. 11 Wired microphone port: insert the microphone with 6.35 "connector to use the microphone. Charging indicator light: the red light is always on when charging, 12 and the red light is off when fully charged. 13 USB charging port: connect the USB cable, and connect the charger or computer USB port to charge the speaker. 14 U disk interface: insert U disk to play songs in U disk.
FM RADIO Default search frequency:87.5-108MHZ 1. Power on,short press M / light button to switch FM mode,the FM frequency will be displayed. 2. Long press enter into auto searching,after the station search is completed, the station will be saved automatically. 3. Short press button Play/Pause. 4. Short press button to play next station. 5. Short press button to play previous station. USB MODE Maximum U-disk capacity supported: 32G Supported song formats: MP3 WMA WAV FLAC APE . 1.
MICROPHONE MODE 1. After power on, insert the microphone with 6.35" interface, and the speaker will automatically enter microphone mode. 2. Insert the microphone with 6.35" interface before power on. After power on, it needs to plug in and unplug the microphone interface again, so that the microphone can work normally.
Bluetooth profiles: Working current: Working voltage: A2DP, AVRCP, HFP ≤1200mA 3.3 - 4.2V Charging voltage: Charging current: Battery capacity: Static standby current under shuttdown status: Static standby current under power on status: DC 5V ≤1000mA 3600mAh ≤2uA ≤170mA Charging time: Playtime at full volume: Playtime at 60% volume: Waterproof: about 4-5 hours about 2.5 hours about 7 hours IPX6 Notice: IPX6, this speaker is fully water resistant and dust proof. Do not soak it under water.
REMOTE CONTROL Short press ON/OFF(Turn the power switch to the left and turn it on.) Mode Mode REC Light 1 2 3 4 5 6 7 8 9 Light Short press Mute/Un-mute Short press previous track 0 REC Short press to switch mode. Short press Pause/Play. Long press disconnect current BT. Short press next track After inserting the microphone,long press to switch reverberation,depth (EC01 EC02 EC03). In the mode of U disk / TF Card, short press to switch single cycle / play in sequence.
WIRED MICROPHONE INSTRUCTION 1.Please power on SPLASH-XTREME and insert the wired microphone into the SPLASH-XTREME slot, and then power on the microphone. After that, the “MIC” wording appears in the SPLASH-XTREME screen display. 2.If the wired microphone is inserted while SPLASH-XTREME in power off status, there is no any working function for the microphone. You will need to re-insert the microphone. WARRANTY POLICY Your speaker is covered by a limited warranty.
FCC WARNING >>> This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.