Use and Care Manual

ManualsBrandsGT-LITE ManualsCommercial Lighting5,000 Lumens LED Work Light with USB

WORK LIGHT CONSTRUCTION:

A. Carrying handle with comfort grip

B. Lightweight, scratch-resistant aluminum frame

C. Tiltable light face

D. LEDs

E. Tempered glass protective lens

F. Tangle-free grounded power cord

G. Side star knobs (2)

H. On/Off switch

I. USB port

J. U-frame

K. Base knob (1)

L. H-stand base

M. Textured rubber feet for strong surface grip

ASSEMBLY:

1. Attach U-Frame (J) to H-Stand (L) by screwing Base Knob

(K) completely through the holes on (J)+(L) until tight.

TO USE:

1. Place H-Stand (L) on a sturdy surface. Ensure that all 4

Rubber Feet (M) have a secure grip on the surface.

2. Slightly loosen side Star Knobs (G)(do not unscrew

completely).

3. Tilt Light Face (C) up or down to the desired angle.

4. Tighten Star Knobs (G).

5. Slightly loosen Base Knob (K)(do not unscrew completely).

6. Swivel U-Frame (J) side to side to the desired angle.

7. Tighten Base Knob (K).

8. Plug Power Cord (F) into outlet.

9. To turn light on, switch On/Off (H) to On position (–).

10. To turn light off, switch On/Off (H) to Off position (o).

11. To charge a device, plug device into USB port (I). USB port

works with LED light on or off, as long as the unit is plugged

into power outlet.

12. Store in a cool dry place when not in use.

TROUBLESHOOTING

Problem

Cause

Solution

LED is not

lighting up.

No power or faulty

connection.

Check that all

connections are secure,

and power is ON.

Questions,

Missing Parts

Customer Service:

1-800-865-6799

CARE AND CLEANING

Your fixture is made from quality materials that will last an

extended period of time with proper care—including periodically

cleaning the surface of the fixture.

1. Use a mild, non-abrasive cleaner. Do not use any solvents or

harsh cleaning agents.

2. Use a soft, non-abrasive cloth.

3. Lightly spray cleaner onto the cloth. Do not spray liquid

cleaners directly onto LEDs, power cord, or any part of this

product.

4. Lightly wipe down fixture with damp cloth. Allow product to dry

completely before restoring power and using LED lights.

NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient

or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3)

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

(4) Consult the dealer or an experienced radio/TV technician for help.