Completes LED Lighting Solutions ITE} VITAL BANQUETER (MEY WARNING: & GT-Lite Whrrtrty Installation: GT-BU-PRY | 353-9980 | Rotating Disco Party Bulb Watts: 2W Lifespan: 5,000 Hours Operating Voltage: 120V Color: RGB Red + Green + Blue Age: E26 / Standard Edison Base Operating Temperature: -4°F to 113°F (-20°C to 45°C) Ballast must be bypassed if present. When using product, basic precautions should always be followed. Read and follow these instructions and observe all wakings.
Installation: GT-BU-PRY | 353-9980 | Rotating Disco Party Bulb A ADDITIONAL WARNINGS: A Do not dismantle this light. There are NO replaceable LED or serviceable parts. Do not install this light inside of undersized enclosures. Suitable for fixtures rated for temperatures ranging from -4'F to 113'F NOT Suitable for enclosed fixtures. Do not use where exposed to standing water. Do not leave bare wires exposed outside of the electrical connections. Make sure wiring section is insulated.
Installation: GT-BU-PRY | 353-9980 | Rotating Disco Party Bulb INSTALLATION INSTRUCTIONS: 1. Before installing the bulb, it is recommended to shut off power supply at the circuit breaker panel to avoid electrical shock. 2. Remove old bulb. 3. Screw disco party bulb in clockwise. Do not over tighten. Over tightening may cause damage to the light. 4. Restore power to fixture. 5. Turn on light switch. Bulb will illuminate and begin rotating immediately. 8.
Installation: GT-BU-PRY | 353-9980 | Rotating Disco Party Bulb INSTALLATION DIAGRAM: (Live) % (Live) Standard oS E26 LED E26 Bulb Disco Bulb Be sure to wire fixtures properly. Improper wiring greatly increases TROUBLESHOOTING GUIDE: your risk of electrical shock. Problem Probable Cause = Solution Fixture does Bad connection. = Check wiring connections. not turn on. Faulty switch, Test switch or replace it. Power is off. Verify power supply is on.
