Contents 1. Products list 2. Specification 3. Connecting Instruction. 4. Loudspeaker installation5. Attentlon- 8.USB Setting 7.LED Status -perpetration 1.Normal Mode 4.Sounds choice setting 9.
1 Aircraft simulated sounds system control mold x PCs 2 Plane special resonance speaker x PCs 3 ESC connect cable x PCs 4 Micro USB data cable X pes 5 Power cable x PCs 6.5mm whits LED x 2°2 pos 5mm red LED x Zoos 5mm green LED x Tics 7 Accessory bag x poss 8 Double-sided fixed taps x PCs. 9.
input channel: Output channel From up to down: From up to down: 1. Emply 1 Empty 2 Throttle channel (Calvert} 2 Throttle channel (electrically 3.Landing gear light control controlled) 4. Empty 3 Steering gear channel 4 Empty 1. Clean the surface to which the speaker is pasted and press when You paste. For better bonding, allow for 24-hour standing. Recommendation: Use glue to pasts the vibration ring 2. Install the loudspeaker as horizontally as possible.
Please use the speakers produced or recommended officially. Non-certified speakers can be problematic. Use glue to stick the loudspeaker {positive) in the Inside of the aircraft, and make sure it won't fall off. Please assemble it according to the manual strictly and keep it stable and safety.
1.The device support update settings by computer software, please visit our website and download the latest PC-side software, or connect the device to the computer, double clicking to Install the PC software In the SD card of the device (file name: 2.After completing download and Installation, connect the device to the computer, long press “ESC” to enter the USB mode; using the software “Aircraft Sound Simulator”, can set the Information of device, for example, the engine sound, battery, lights.
to the timing that you set. The engine will restart only when you touch the throttle again, you can also choose to shut down, but the sound system will work all the time when the engine Is working. (3)The sensitivity of starting: lower sensitivity can prevent the mistake starting when the controller and the throttle rocker occur slightly touched. If sound equipment start and your aircraft start are out of sync, you can try to adjust here.
1.Standard light mode (Default), the LED flashing according to the diagram below: LED care | Baas an | Isobar | Landing agar | of wing | it wing ght light ght light light Fred) | (wie) | white) red) [green Aircraft Flash Flash Normally Normally normally the Startup $3 | lowly | quickly | controverted) | on on stalled state off oft off off off 2 Blasting flash made: All the LED flashing together at a fast pace. 3.Normally on mods: All the LED light up together. 4.
1.Normal mode Power on It, push the throttle to the minimum, the first LED flashing, then working ok. Push the throttle to forwards, the Motor running, after finish the sounds of throttle switch on, the motor will make a sound to match the rotation rate of the motor according to the single source of the throttle. At the same time, the LED of the device will show the status of the speed of revolution. apes Blue LED and apes Red LED lighting at the same time, tt means that the throttle in maximum.
“Escape. Then the loudspeaker sounds “Bee, Bee”, and LED 3 flashing. It can update the sounds file and Information when connect the computer to USB port. And It will stop to the USB mode when long press “Esc” or plug out the USB connecting cable. 4.Sounds choice setting In normal mode, it will enter to the sounds choice mode after long press “Mode”, then the loudspeaker will sounds “Bee” "Bee". After that, it will play the per-listening effect of current sounds.
2.Don't accept due to the modified without authorization or other function machine malfunction after loading. 3.Please refer the invoice once altered, not be warranty. 4.
