Users Guide

DrawingBoard VI 32
To replace the batteries:
1. Place the cursor face down in the
palm of your hand. Use a Phillips
screwdriver to remove the two
screws located on the bottom of
the cursor (see figure). Remove
the cursor base.
2. Remove the old batteries from the
battery casings.
3. Place the new batteries in the
casings, matching the polarity of
each battery with the markings on
the connector strips (match + to
+).
4. Reposition the cursor base.
Replace the screws with the
Phillips screwdriver.
NOTE: When you replace the cordless cursor batteries, the cursor will reset to the default
frequency. If you changed the frequency of the cursor before replacing the batteries, you
will need to do so again after replacing the batteries (see the Reducing Monitor
Interference section in Troubleshooting).
Troubleshooting
GTCO CalComp by Turning Technologies wants your experience with DrawingBoard VI to
be a successful one. If you ever encounter a problem, please follow the steps below.
1. Review this User’s Guide to verify you have performed the correct steps.
2. Read the topics below to check for a solution to your problem. Assess the
checklists, as well as the Troubleshooting Chart. Keep in mind that the problem
could be your computer, display or software, instead of the digitizer.