Quick Start Guide Instruction Manual

Contents

Verify that your Roll-Up III package includes the following:

 Roll-Up III digitizer and controller

 Transducer (stylus, 4-button or 16-

button cursor)

 USB cable

 CD with TabletWorks driver and

user’s manual

 Accessory pouch*

 Shipping/storage tube with insert*

*Do Not Discard

Optional Equipment

 Plan hold down clamps

 Deluxe travel case

 QuikRuler LCD module

 Serial interface cable and power

supply kit

Hardware Configuration

NOTE: Setup the hardware connections for USB or serial FIRST, following the instructions

below, then install the software.

Installing Roll-Up III

The following instructions describe how to assemble your Roll-Up III. Select a large, flat,

non-metal surface on which to place the digitizer. Clear all items from the surface.

NOTE: Conductive materials, inks, or

electronic devices on, under, or near the

Roll-Up III can cause improper operation.

PAGE 1
Contents Verify that your Roll-Up III package includes the following:    Roll-Up III digitizer and controller Transducer (stylus, 4-button or 16button cursor) USB cable    CD with TabletWorks driver and user’s manual Accessory pouch* Shipping/storage tube with insert* *Do Not Discard Optional Equipment   Plan hold down clamps Deluxe travel case   QuikRuler LCD module Serial interface cable and power supply kit Hardware Configuration NOTE: Setup the hardware connections for USB or serial FI
PAGE 2
NOTE: Connect ONLY USB or serial – not both. USB Connection – With TabletWorks CD Only – 1. Connect the transducer – cursor or stylus – to the appropriate jack on the digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack. Do not force it. 2. Attach the USB interface cable to the USB jack on the Roll-Up III Connector Panel. The connector is keyed and will fit only the correct jack. Do not force it. 3.
PAGE 3
Software Configuration NOTE: To configure Roll-Up III for use with a third-party application, please refer to the installation instructions in the Roll-Up III User’s Guide, or the Roll-Up III Help file. Software drivers provide the communication bridge between your software application and the Roll-Up III. If you received a CD with your purchase, it will either be a GTCO CalComp by Turning Technologies-supplied CD or a third party CD provided by the software application vendor.