User's Manual

Estate Intercom/Keypad Features
Keypad
• The keypad illuminates and beeps at the press of any key. At night, the keypad will illuminate when the proximity sensors
detect motion near the keypad face.
• When a valid code is entered, the STATUS light will blink rapidly, the keypad will beep three times, and the GRANTED
light turns green.
• The keypad remains active for 40 seconds after entering a valid code: pressing any key on the keypad while the gate is
in motion will stop the gate; pressing any key while the gate is stopped will cause the gate to reverse direction. After 40
seconds, the keypad will
beep 3 three times and go into “idle” mode, and the GRANTED light will turn off.
• If more than 20 key presses are entered without matching an Entry Code, the STATUS light will flash rapidly, an error tone
will sound for 1 second, and the keypad will go into “lock-down” mode for 40 seconds.
• If more than 10 seconds elapse between key presses, the keypad will beep 3 three times and go into “idle” mode.
Master and Entry Codes
• Up to 100 Entry Codes may be programmed into the keypad.
• Temporary Entry Codes can be programmed to expire within one to seven (1–7) days.
• Entry Codes remain stored in memory even when the keypad batteries go dead.
• All Entry Codes are deleted by pressing the RESET button on the keypad; Master Code defaults to “1234.”
Base Unit
• The base unit is powered by a rechargeable battery (included); the charge is maintained by the transformer.
• The base unit can be disconnected from the transformer allowing it to be moved anywhere within range.
• Up to three additional base units can be added to the system.
NOTE: The keypad, not the base station, initiates the call and operates the gate. The base station is for answering
calls and granting “permission” for the gate to be opened.
INTERCOM/KEYPAD SPECIFICATIONS
Frequency 318 MHz from keypad to gate opener
915 MHz from keypad to base station
Memory – Keypad Stores up to 100 four-digit entry codes
Power Consumption – Keypad 60 mA when relay is closed
Power Supply – Keypad Four C batteries (plus 8-24V DC/AC for hard-wired installations)
Power Supply – Base Unit 9 Vdc 300 mA transformer; 3.6V Ni-MH 800 mA rechargeable battery
pack
Range from Keypad to Base Unit 500’ wireless
Range from Reypad to Gate Opener 50’ wireless 100’ wired using 16 AWG wire
Relay Output – Keypad Momentary, normally open dry contact closes for 2 seconds upon
activation
Relay Output Rating – Keypad 12 or 24 Vdc 100 mA
Wiring – Keypad Power & Relay Output 16 AWG stranded low voltage direct burial wire