User's Manual

Test safety edge connection by pressing the safety edge. The SGET alarm will
beep 4 times.
Refer to receiver programming instructions to set the receiver into the program
mode. Press the button to program the unit identication code into the receiver.
Replace transmitter cover.
Activate the gate to close. As the gate is closing, press the safety edge with
your hand. Gate should stop and reverse
Remove the transmitter cover and remove old batteries. Replace two “C” batteries
and replace transmitter cover.
STEP 7 Test Safety Edge
STEP 10 Test System
STEP 8 Program Transmitter STEP 9 Close Transmitter
STEP 11 Replacing Batteries
This Linear PRO Access (LPA) product is warranted against defects in material
and workmanship for twelve (12) months. The Warranty Expiration Date is
labeled on the product. This warranty extends only to wholesale customers
who buy direct from LPA or through LPA’s normal distribution channels. LPA
does not warrant this product to consumers. Consumers should inquire from
their selling dealer as to the nature of the dealer’s warranty, if any. There are no
obligations or liabilities on the part of LPA for consequential damages arising
out of or in connection with use or performance of this product or other indirect
damages with respect to loss of property, revenue, or profit, or cost of removal,
installation, or reinstallation. All implied warranties, including implied warranties
for merchantability and implied warranties for fitness, are valid only until Warranty
Expiration Date as labeled on the product. This LPA Warranty is in lieu of all
other warranties express or implied.
All products returned for warranty service require a Return Product Authorization
Number (RPA#). Contact LPA Technical Services at 1-800-543-1236 for an
RPA# and other important details
Linear PRO Access radio controls provide a reliable communications link and fill an
important need in portable wireless signaling. However, there are some limitations
which must be observed.
Copyright
©
2017 GTO Access Systems, LLC
Document Number: 10016915 REV A (05-15-17)
LIMITED WARRANTY IMPORTANT
REMOVE/REPLACE
COVER
REMOVE/REPLACE
“C” BATTERIES
PRESS
EDGE
CLOSE GATE
REPLACE
COVER
CAUTION: DO NOT STAND IN THE PATH
OF THE CLOSING GATE.
PRESS THE
PROGRAMMING
BUTTON
SGER
PRESS EDGE
WITH HAND
Troubleshooting
SGET Alarm Fault? Condition
Code
Low Batt 1 NO Low Battery
Open 2 YES Edge not present
No Ack 3 YES SGET not able to send message (dead or too
far away)
Edge 4 YES Edge shorted
PRINTERS INSTRUCTIONS
INSTR,INSTL,SGER SERIES - GTO P/N: 10016915 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.500” X 11.000” - SCALE: 1-1 - SIDE 2 of 2
WARNING: Changes, modications or adjustments not expressly approved by GTO
Access Systems, LLC could void the user’s authority to operate this equipment.
There Are No User Serviceable Parts.
NOTICE: This device complies with part 15 of the FCC rules and with Industry
Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation
of the device
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.