User's Manual
 GTO 4000XLS Instruction Manual © 01.10.12 5
Transformer (1) 
Battery (1) 
Control Box (1) 
Warning Signs (2)
GTO Transmitter(1) 
1.  KEEP CLEAR! Gate may move at any time. 
2.  Do not allow children to operate gate or 
  play in gate area. 
3.  This gate is for vehicles only. Pedestrians 
  must use a separate entrance. 
Moving Gate Can Cause 
Injury Or Death 
WARNING 
! 
Receiver (1) 
ON/OFF
6. Materials You may Need for the Installation: 
Depending on the type of gate and post, you may need some additional materials/hardware. 
 •Lowvoltagewire
[RB509]. Length depends upon the distance between the transformer power 
supply and the control box. (Page 13)
 • Ifthegateismorethan1000’awayfromanACpowersourceyouwillneedtouseatleastone10
watt Solar Panel 
[FM123] to trickle charge the battery. (Page 2)
 • PVCConduit.(Page6)
 • Thediameterofthepostshouldbeatleast6”inordertomountthepostbracket.(Page6)
 •Dependinguponthediameterofthepost,youmayneedlongerboltsthanthoseprovided.Bolts
should be at least 1” longer than the diameter of the post. (Page 6)
 • Metalplateforwoodenposts.(Page6)
 • Ahorizontalorverticalcrossmemberormountingplatemaybeneededtomounttheoperatorto
the gate. (Page 3)
 • SometypesofinstallationsrequireU-Bolts.(Page10)
 • Surgeprotectionfortransformer.(Page15)
 •Weatherproofcoverfortransformerifinstalledoutside.(Page15)
 • Forpush-to-openapplicationsyoumusthavePTOBracket
[R4KPTO). (Page 21).
Drill Bit 
Drill
Pliers
Level
Small, Medium, Large
Clamps
Adjustable
Wrench
Pen
Center
Punch
Hammer
Tape
Measure
Small
Flat Head
Phillips Head
Screwdriver
Flat Head
Screwdriver
Wire
Stripper
Hack Saw
Open End Wrenches
5. Tools Needed
•PowerDrill •Pliers
•Level •TapeMeasure
•WireStrippers •CenterPunch
•OpenEndWrenches:
9
/16” and 
3
/4” 
•DrillBit:
1
/2” 
•HacksaworHeavyDutyBoltCutters
•Small(FlatHead)Screwdriver
•PhillipsScrewdriver
•C-Clamps:small,medium,andlarge
•AdjustableWrench
•Extrapersonwillbehelpful










