Specifications

7
The system integrator must place an exterior label on the outside of the final product
housing the CPDL70W-1 Modules. Below is the contents that must be included on this
label.
The host product Labeling Requirements:
NOTICE: The host product must make sure that FCC labeling requirements are met. This
includes a clearly visible exterior label on the outside of the final product housing that
displays the contents shown in below:
Model: CPDL70W-1
Contains FCC ID: 2ATQ5-CPDL70W-1
5.8 Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB Publication
996369 D04 Module Integration Guide for testing the host products. The host
manufacturer may operate their product during the measurements. In setting up the
configurations, if the pairing and call box options for testing does not work, then the host
product manufacturer should coordinate with the module manufacturer for access to test
mode software.
5.9 Additional testing, Part 15 Subpart B disclaimer:
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.249)
list on the grant, and that the host product manufacturer is responsible for compliance to
any other FCC rules that apply to the host not covered by the modular transmitter grant of
certification. The final host product still requires Part 15 Subpart B compliance testing with
the modular transmitter installed when contains digital circuity.