Specification For 55 Inch LCD Monitor Buyer: Model: LT55BN93L December, 2014
Product Specification CONTENT Number Item Page 1 General Description 3 2 Product Specification 4 3 Power supply connector 5 4 Image signal input interface 6 5 Keyboard Operations Guide 7 6 Block diagram 8 7 Mechanical Characteristics 9 Page1 LT55BN93L Ver.
Product Specification Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Product Specification 1. General Description This product is used to display an image, using a DVI cable to connect the game console. This product uses DC 24V(6A) and DC 12V(2A) power supply. The main components AD Board M.RT2261.5B LCD Module LG Display LC550DUN/DUE Frame SECC 1.2mm thickness 2. Product Specification Panel Signal Input Power Supply Display type TFT LCD Backlight type WLED Light bar Dead dot Less than 3 Aspect ratio 16:9 Pixel Format 1920 horiz. by 1080 vert.
Product Specification 3. Power supply connector Connector type: YLR-06V Pin configuration No 1 2 3 4 5 6 Description +12V +24V +24V GND(12V) GND(24V) GND(24V) Color of wire RED RED RED BLACK BLACK BLACK Page4 LT55BN93L Ver.
Product Specification 4. Image signal input interface DVI-I input VGA input AD Board box Pin configuration of VGA interface Pin No. Pin description Pin No. Pin description 1 Red 9 DDC 5V 2 Green 10 GND for Sync. 3 Blue 11 ID0 4 ID2 12 ID1(SDA) 5 GND for Data 13 H. Sync. 6 GND for Red 14 V. Sync 7 GND for Green 15 ID3(SCL) 8 GND for Blue Pin configuration of VGA interface Pin No. Pin description Pin No. Pin description Pin No.
Product Specification 5. Keyboard Operations Guide Control Key Serial Number LED Indicator FCC ID a. Auto configuration (VGA input only valid) When monitor connected to the VGA signal and power on, it will automatically adjust the image to the optimum image center / magnitude / phase and so on. If the center of the image and the magnitude is not the best, press the "Auto" key, the monitor will automatically adjust the image again. b.
Product Specification Press the "power" key can switch on or shutdown the monitor. This monitor can store switch state before the power supply failure. g. Other adjustments The monitor is shipped, has all image adjustment parameters set to default the best value, in addition to brightness/contrast should be adjusted according to the actual signal status and user requirements, other project proposals no necessary adjustment.
Product Specification 6. Block diagram lCD module(LC550DUN) LVDS signal T-CON baord Backlight LED driver +12V backlight on/off CN11 DC Power input +24V LED control CN12 CN16 Key control DVI&VGA Keypad(5keyled1) AD board(RT2261) Page8 LT55BN93L Ver.
Product Specification 6. Mechanical Characteristics Page9 LT55BN93L Ver.
