Operating Instruction Model: E-9150/ PWPBT60 Bluetooth Portable speakers Rev 0.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS............................................................................... 2 BEFORE USE ................................................................................................................... 4 COPYRIGHT.................................................................................................................... 4 BLUETOOTH CONNECTIVITY ...........................................................................................
curtains and the like. 9. Install the apparatus in accordance with the manufacturer’s instructions. 10. Clean the cabinet with a soft cloth slightly moistened with a mild detergent solution. Do not use strong solvents which may cause unpredictable damage to the apparatus. 11. Do not use attachments/accessories not recommended by the product manufacturer as they may be hazardous. 12. Power-supply cords should be routed so that they are not likely to be trapped in any way.
2. If this product develops trouble, contact qualified service centers, and do not use the product in defective states. BEFORE USE 1. Choose unit installation location carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, cold or moisture. Keep away from sources that hum, such as transformers or motors. 2. Do not open the cabinet as this might result in damage to the circuitry or electrical shock.
NOTE: The effective distance between your external device and this apparatus is 5 meters. 3. Wait for a while then find the “E-9150” on the paired devices list on your external device and press “E-9150”. If sometimes A window will ask you a password. Fill in “0000” then press “OK” on your external device. 6. A few seconds later your Bluetooth connection is success. And you can hear “dodo”. ENJOY MUSIC FROM AN EXTERNAL DEVICE 1.
Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
SPECIFICATIONS AMPLIFIER section Output Power Frequency Response SPEAKER SYSTEM section Type Impedance …………. …………. 3.0W X 2 60 to 20,000 Hz …………. …………. 1-way 4 Ohm Output Power …………. 2x2.5w GENERAL Power Requirements …………. Dimensions (W x H x D) …………. USB Charge Standard Accessories …………. …………. The built-in lithium battery voltage 3.7V Lithium battery capacity:1400mA 65 x 70x 201 mm(approx.) Without hand buckle 65x70x216 mm(approx.