User's Manual

Table Of Contents

C. Add Devices

·DC 12V power supply, add device through connecting WIFI,

Automatically add

·Please make sure the WIFI signals can cover the doorbell's installation area. Connect

your mobile phone with WIFI, login the APP > click the “+” button > WIFI conﬁguration

enter the WIFI password > start conﬁguration. You can know whether the WIFI >

conﬁguration is succeed by the outdoor unit's indicating information. (If the device is

already connected with the network, this function will be invalid and restoration operation

is needed if you want to restore the function. Please refer to the restoration operation .

·After the device is successfully connected to the network, all the devices on the LAN will

be found and displayed on “My device” list. (Please see the pictures below.)

Click the “+” button on the top right corner, scan the QR code and then you can add the

device shared by your friends.

4 5

1) Edit the device name

On “My device” page, click the “Setting” button on the right side to enter device setting interface.

Click the “Device Name” to enter device name setting, input the device name you want to set and

then click “ok” to save the setting. (Please see the pictures below.)

D. Device Settings

2) Motion detection setting

Click the “Motion detection” button to enter the setting page, turn on this function and then select

the detection time. Note: The motion detection function will be on only during the detection time

you selected. Click the “√” button on the top right side to save the setting. (Please see the pictures

below.)

·APP installation instructions.

·Scan the QR code on the package box to download the APP by your smart mobile

phone/apad/ipad etc.

Operation Instruction

1). Adopt high-performance ARM SOC chips, 720P CMOS sensor, 85° viewing angle and H264

encode, support infrared night vision function and the night vision range reaches 1.5 meters.

2). Support WIFI or wire connection with internet. Adopt 802.11b/g/n protocol, support one-click

wiﬁ password setting.

3). Motion detection function, alarm signals can be sent to the user's mobile phones.

4). Remotely SmartLock unlocking function.

5). Adopt professional digital noise reduction and echo cancellation algorithm, duplex two-way

intercom is available on both the device terminal and the mobile phone app.

6). Max 8 users' APP can be connected to the device at the same time.

7).Users can share the device QR code for his friends to connect with the same device.

A. Product Introduction.

B. Installation

·Power supply instruction.

· DC 12V Power Supply .

· The doorbell can wireless connect with home routers, but if the router's signal is too

weak to cover the installation area, high power router is recommended.