User Manual

UHF Integrated RFID Reader Manual Guangdong Sygole Intelligent Technology Co.,Ltd
8
media)
Buffer——Refers to the distance from the reader to the metal surface
1. The buffer is 0cm, that is, when directly mounted on the metal surface, the read/write
distance of the reader/writer will be reduced by at least 10%; the specific data is related
to the metal material, size, thickness, etc.;
2. When the buffer is ≥20mm, the performance of the reader is close to that of the non-
metal plane; it is recommended to design the buffer to be larger than 20mm during
installation.
Fig 3.4.1 Nut type reader metal environment installation
If the reader housing is made of metal, it is recommended to use a plastic bracket when
the ground is not good.
Embedded metal mounting——Reserve a free area that is large enough.
Free zone——Refers to the metal blank area around the reader when the reader
is embedded in the metal installation.
1. When A = 0cm, that is, when the reader is installed without a reserved free
area, the read/write distance of the reader will be seriously reduced. This
installation method is not recommended;
2. When A = 10cm, the actual reading and writing distance of the measured is
reduced by 10%; the specific data is subject to the actual application test;
In order to meet the requirements of reading and writing distance, it is necessary
to reserve enough free zone in the actual application (the recommended value
of A is not less than half of the length and width of the reader);
Fig 3.4.2 Embedded metal environment