Parts List

ManualsBrandsGUANGDONG SYMA MODEL AIRCRAFT INDUSTRIAL ManualsToys & GamesRC TOYS

BATTERY CHARGING

BATTERY PRECAUTIONS

BATTERY MAINTENANCE

Charging helicopter with USB:

To charge the battery, please connect the

USB charger to the USB port in your

computer and connect the other end to the

USB port in your helicopter. When the

battery is charging, the USB light will be red.

When the battery is fully charged, the light

will turn to blue.

1. Don't use or leave the battery near a heater or any heat source.

2. Adult supervision is required when charging.

3. Allow the helicopter to cool down after flying before charging the battery.

4. To avoid inner short-circuit, don't hit or allow the battery to fall during

charging.

5. Charging should only be done by using the included adaptor. Please

replace batteries periodically.

6. When the battery has finished charging, please remove the charger. If the

charger is not removed, the battery will discharge and recharge again,

shortening your battery life.

1. Store batteries in a 64.4-77℉ cool, dry environment.

2. To preserve battery life, do not allow batteries to discharge and recharge

over and over. Do not over discharge.

3. Please charge the batteries to be 50-60% before long term storage.

4. Check battery voltage regularly, especially if storing for a month or longer.

If the voltage is lower than 3V, recharge to 50-60%.

Charging time: about 70 minutes Flying time: about 5 minutes

Note: Make sure the helicopter is turned off while charging

Summary of content (6 pages)

PAGE 1
BATTERY CHARGING Charging helicopter with USB: To charge the battery, please connect the USB charger to the USB port in your computer and connect the other end to the USB port in your helicopter. When the battery is charging, the USB light will be red. When the battery is fully charged, the light will turn to blue. Charging time: about 70 minutes Flying time: about 5 minutes Note: Make sure the helicopter is turned off while charging BATTERY PRECAUTIONS 1.
PAGE 2
PARTS
PAGE 3
Code Description Quantity Code Description Quantity Code Description Balance bar Main motor B Tail blade Upper connection buckle Upper left aluminum sheet Tail motor Main shaft Lower left aluminum sheet Vertical fixed tail Inner shaft Main stand Tail tube Upper blade grip set Lower right aluminum sheet Fixed Horizontal tail Upper blades Upper right aluminum sheet 2.
PAGE 4
Gear Upper blade grip set Lower blade grip set Inner shaft Battery cover Tail motor assembly Aluminum sheet Motor A Motor B Battry PCB board USB cable Motor cover Tail Decoration-red Tail Decoration-white Transmitter TROUBLE SHOOTING Possible Causes Helicopter can not move Helicopter insensitive reaction 1. Weak battery. 2. Controller power weak, indicator flashing. 1. Controller power weak. Solutions 1. Recharge the helicopter. 2. Replace controller batteries. 1.
PAGE 5
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 6
DIMENSIONS 9.8in 5.7in 12.8in 2.4in 12.8in 2.4in 5.7in 9.8in DISTRIBUTED BY: Rural King Distributing Mattoon, Illinois 61938 www.ruralking.