User's Manual

Use the scale
Startup
The Welch Allyn weight scale uses SENSE ON™ technology to turn on the scale. Step
on the scale with bare feet to begin a measurement.
Insert or replace the batteries
CAUTION When the symbol appears, the device will power off
in four seconds. Replace the old batteries with a new set of four batteries.
Always replace all four batteries with new batteries. Do NOT mix old
batteries with new batteries
CAUTION Remove the batteries if the device is not to be used for some
time.
CAUTION Dispose old batteries by following your local recycling
guidelines.
CAUTION Do not burn batteries. Batteries may leak or explode.
1. Open the battery door on the under side of the scale.
The digits “8888” appear on the LCD screen.
2. Insert the four AAA alkaline batteries (1.5V each) into the battery compartment
according to the polarity indications marked inside the battery compartment.
3. Close the battery door.
4. Wait until the digits “0.0lb”appear on the LCD screen.
Pair a connection hub with the scale
With advanced Bluetooth 4.0 Technology applied, a communication hub is capable of
receiving your personal health data. Contact your Remote Patient Monitoring Solution
provider for connectivity instructions and troubleshooting.
1.
Confirm that both the connection hub and the weight scale are powered on.
Note Bluetooth wireless connectivity is only available for devices
which support Bluetooth 4.0 technology.
7