User's Manual

Insert the Batteries

Open the battery door in the back of the scale.

Insert the batteries (4 x 1.5V AAA) into the battery

compartment according to the polarity indications

marked inside the compartment.

* The digits “8888” will be shown on the LCD.

Close the battery door and wait until the digits

“0.0lb” are shown on the LCD.

CAUTION

When the symbol appears, the device will power off in four seconds. Then you shall replace with a

new set of batteries. Please replace all four batteries at the same time. Do NOT mix the old batteries with

the new one.

Worn batteries are hazardous waste. Do NOT dispose of them together with the household garbage.

Please refer to the local ordinances and recycling instructions regarding disposal of the worn batteries

and scrapped device.

If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the batteries

before storing.

If SUCCEED, symbol will be shown on the LCD.

If FAIL, symbol “E1” will be shown on the LCD.

Install App and Pair-Up

With the advanced Bluetooth 4.0 technology applied, the mobile or portable equipments,

which are equipped with Bluetooth function in line with BLE Technical Specifications as

well as BLP Protocol established by global organization Bluetooth SIG, are capable to

receive your personal health data.

Just simply install the specially-designed app and pair up your scale with

your mobile or portable equipments. Then you may enjoy the comprehensive health

solution provided by Transtek.

Turn on Bluetooth and App. Make sure both are ON when pair-up is

proceeding.

Press and hold “UNIT” button in the back of the scale to start pair-up.

Symbol and symbol will be shown on the

LCD alternatively, indicating pair-up is proceeding.

Initial Start-Up

Note: It is only available for the device which supports Bluetooth 4.0 technology.

Initial Start-Up