User's Manual

76
BEFORE YOU STARTBEFORE YOU START
1. The battery of LS810-B is built-in rechargeable
lithium-ion battery, the battery current is 420 mAh.
2. Please use the AC adaptor and USB cable to charge
the battery, just like the following picture:
Power Supply and Charge Power
Setting Date and Time
Charging the power under following circumstances:
displays on the LCD
The LCD display dims
When powering on the monitor, the LCD doesn’t light up.
2.As pictured in the right, the
blinking numeral “12” representing
[HOUR]. Press “MEM” button to
change the numeral. Each press
will increase the numeral by one
in a cycling manner.
1.When the monitor is OFF, press
and hold “SET” button for 3
seconds to enter Time Setting
Mode.
3.Press “SET” button again to
confirm [HOUR]. Then the
numeral representing [MINUTE]
blinks.
Please proceed to time setting before your initial use so as to
ensure each piece of record are labled with a time stamp. (Year
Range: 2012-2052; Time Format: 12 Hours)
AC adaptor
CAUTION
1. The battery of LS810-B is built-in rechargeable lithium-ion battery,
please do not disassemble
it by the unauthorized maintenance personel.
2. Under the normal using, it can charge power about 300 times,
if the battery cannot charge the power normally or the blood pressure
monitor cannot use normally, please connect with the authorized
maintenance personel.
3. Storge and use the blood pressure monitor at the cool, dry and
ventilated environment. Avoid to approach to the fire and the heat
source, or it will cause the battery explode.
4. Only can use the Transtek’s authorized AC Adaptor
(Model: UE0WCP-0501000SPC) to charge the power. You cannot
use the blood pressure monitor during the process of charging.
5. During the process of charging, the blood pressure monitor display
When the
charging is finished, please pull the plug in time.
6. When charging, shall not touch charging connector and the patient
simultaneously.