version:1.0 User Manual Blood Pressure Monitor TMB-1591-BS Arm Type FCC ID:OU9TMB1591B2 Guangdong Transtek Medical Electronics Co., Ltd. Zone A, No.105 ,Dongli Road, Torch Development District, 528437 Zhongshan,Guangdong,China Thank you very much for selecting TRANSTEK Blood Pressure Monitor TMB-1591-BS. To use the monitor correctly and safely, please read the manual thoroughly. Please keep this manual well in order to reference in future.
CATALOGUE Table of Contents INTRODUCTION........................................................................................2 General Description Safety Information Indications for Use Contraindications Measurement Principle LCD Display Signal Monitor Components BEFORE YOU START................................................................................8 The Choice of Power Supply Installing and Replacing the Batteries MEASUREMENT.....................................................................
INTRODUCTION General Description Thank you for selecting TRANSTEK arm type blood pressure monitor (TMB-1591-BS). The monitor features blood pressure measurement, pulse rate measurement and the result storage. The design provides you with two years of reliable service. Readings taken by the TMB-1591-BS are equivalent to those obtained by a trained observer using the cuff and stethoscope auscultation method.
INTRODUCTION CAUTION * This device is intended for indoor, home use. * This device is not intended for public use. * This device is portable, but it is not intended for use during patient transport. * This device is not suitable for continuous monitoring during medical emergencies or operations. * This device is intended for no-invasive measuring and monitoring of arterial blood pressure.
INTRODUCTION INTRODUCTION LCD Display Signal Monitor Components CUFF SYS mmHg AIR HOSE DIA mmHg PULSE /MIN SYMBOL DESCRIPTION LCD DISPLAY EXPLANATION Systolic blood pressure High pressure result Diastolic blood pressure Low pressure result Pulse Pulse/minute mmHg Measurement Unit of the blood pressure Irregular heartbeat Irregular heartbeat detection Battery Indicator Indicate the current battery List Grade The grade of the blood pressure 1. Blood Pressure Monitor 2.
BEFORE YOU START MEASUREMENT The Choice of Power Supply 1.Battery powered mode: 6VDC 4*AA alkaline batteries 2.AC adaptor powered mode: 6V 1A (Can be supplied by AC adaptor model UE08WCP-060100SPA !) Right picture is the hole in for power adaptor. Pairing Turn on Bluetooth and APP. Make sure both are ON when pairing is proceeding. When the blood pressure monitor is off, press On/Standby button for 2 full seconds to enter bluetooth pairing mode.
MEASUREMENT MEASUREMENT Tie the Cuff Start Measurement When the blood pressure monitor is off, press On/Standby button to turn it on, it will finish the whole measurement. 1.Tie the cuff on your upper arm, then position the tube off-center toward the inner side of arm in line with the little finger. LCD display Adjust to zero. 2.The cuff should be snug but not too tight. You should be able to insert one finger between the cuff and your arm. 3.Sit comfortably with your arm resting on a flat surface.
MEASUREMENT MEASUREMENT The blood pressure monitor will proceed to data transmission after measurement. The bluetooth symbol flashes on the LCD indicates data is transmitting. After successful transfer, the device powers off the Bluetooth radio and the icon (and rectangle) are removed. If the user presses and releases the On/Standby button, another reading is initiated. If the user presses and holds the On/Standby button for 2 seconds, the device powers down.
INFORMATION FOR USER INFORMATION FOR USER Tips for Measurement Measurements may be inaccurate if taken in the following circumstances. wait at least 1 hour after dinner or drinking 14 Immediate measurement after tea, coffee, smoking Maintenance In order to get the best performance, please follow the instructions below. Put in a dry place and avoid the sunshine Avoid touching water, clean it with a dry cloth in case.
ABOUT BLOOD PRESSURE ABOUT BLOOD PRESSURE What are systolic pressure and diastolic pressure? When ventricles contract and pump blood out of the heart, the blood pressure reaches its maximum value in the cycle, which is called systolic pressure. When the ventricles relax, the blood pressure reaches its minimum value in the cycle, which is called diastolic pressure.
TROUBLESHOOTING SPECIFICATIONS This section includes a list of error messages and frequently asked questions for problems you may encounter with your blood pressure monitor. If the products not operating as you think it should, check here before arranging for servicing. PROBLEM SYMPTOM No power Low batteries Error message Display will not light up. shows “out ” shows REMEDY Display mode Measurement mode Measurement range Batteries are exhausted.
FCC STATEMENT AUTHORIZED COMPONENT Authorized Component 1.please use the TRANSTEK authorized adapter. Adapter Type: UE08WCP-060100SPA Input:100~240V,50~60Hz,400mA Output:6V 1A ( Conforms to UL certificate ) Contact Information For more information about our products, please visit www.transtekcorp.com.you can get customer service, usual problems and customer download, transtek will serve you anytime. FCC Statement FCC ID:OU9TMB1591B2 This device complies with Part 15 of the FCC Rules.
EMC GUIDANCE EMC GUIDANCE EMC Guidance The ME EQUIPMENT or ME SYSTEM is suitable for home healthcare environments. Warning: Don’t be near the active HF surgical equipment and the RF shielded room of an ME system for magnetic resonance imaging, where the intensity of EM disturbances is high. Warning: Use of this equipment adjacent to or stacked with other equipment should be avoided because it could result in improper operation.
EMC GUIDANCE EMC GUIDANCE Table 3 Guidance and manufacturer’s declaration - electromagnetic Immunity Radiated RF Test IEC61000-4-3 Frequency (MHz) (Test specifications 385 for ENCLOSURE PORT IMMUNITY to 450 RF wireless communications 710 equipment) 745 780 810 870 930 1720 1845 1970 2450 5240 5500 5785 24 Band (MHz) Maximum Distance IEC 60601-1-2 (m) Power Test Level (W) (V/m) Compliance level (V/m) Service Modulation 380-390 TETRA 400 Pulse modulation 18 Hz 1.8 0.