User's Manual

FUNCTIONS MANUAL
Product installation methods
① This product uses the 110-120V~ voltage, electrical construction requires the commission
of professional electrical companies.
② When using this product, tap water pressure must be 0.08Mpa - 0.75Mpa.
③ After the installation, plug the product power into the socket. When you hear a "D", it
means that the product is powered on and the self-test is completed.
④ Please use the water supply pipe attached to the toilet for installation. Do not use the old
water supply pipe, otherwise it may affect the performance of the product.
⑤ Please do not use cloth cover or cushion on the seat, otherwise it may cause seat
induction not good.
⑥ In low-temperature environment, please leave the product in a warm room for 2 hours
before installation to prevent internal moisture from damaging the machine.
⑦ The following picture shows the toilet standard specifications of the product that can be
installed.
1. Precautions before installing the toilet
110-160mm
≥530mm
≥40mm
This series toilet seat cover not suitable
for children-toilet and arch water-tank
toilet (as below pictures shown)
Dimensions of the toilet that can be installed
Above 100mm
Installable water
supply valve
One-piece water tank rear arch toilet
2. The method of separating the installed toilet seat and fixed water purification
filter.
Pipe of
water tank
① Turn the hose valve (supply stop) to the right and lock it,
and then separate the water tank from the water pipe valve
(supply stop) with the water supply pipe.Please use the supply
hose included. Do not use the old one.
② Detach the installed toilet seat. (Disassemble the product
according to the original method of toilet seat. )
Take proper care of seat cover, bolt, nut seal. They will be needed when moving or
reinstalling.
10