User's Manual

User Manual
Andea Electronics http://www.gzandea.com 11/44
5 Use PC Configuration Tool
5.1 Connecting control center of the gate with PC
BUS-OUT
BUS-IN
LCD
USB
RF-OUT
RF-IN
WIFI
ANT1
ANT2
ANT3
AC 220V
Search
BUS-OUT
USB
RS232
INPUT
BUS-OUT
BUS-IN
RF-OUT
RF-IN
BUS-OUT
BUS-IN
LCD
USB
RF-OUT
RF-IN
ANT1
ANT2
ANT3
Communication cable
RF cable
Power cable
Link with power supply
SC gate S gateM gate
Network cable
Link with PC
LAN
Figure 6 LAN port connect between PC and gate
This product supports Ethernet, USB and serial communication. The following
description uses the network port connection as an example:
After connecting the gate and the debugging computer with a network cable
(when directly connected, the debugging computer IP must be set to a static IP),
open the R-TOOL configuration software → pop up the search devices interface →
communication interface: select the network communication (if using USB or serial
communication, then select the corresponding communication interface, and then
click the search button to search for the device.) → Click the ellipsis button behind
the IP address to enter the Ethernet IP discovery interface, as shown below: