User's Manual

User Manual
Andea Electronics http://www.gzandea.com 18/44
library
Detect AFI value
Detect and match the AFI value of the tag. If the AFI
value of the tag is the same as the AFI value set by the
gate, an alarm is issued. Default: Use this.
Note: When the gate detection AFI value is set to 00, all
tags will alarm and 00 means no tags will be filtered.
Detect EAS and AFI
Detect both EAS and AFI.
EAS
EAS Command 1
EAS command type. It is used to detect the EAS status.
You must select the correct EAS command according to
different tag types to correctly detect the EAS status. It is
enabled by default. Default type: NXP Command, also
optional: FM or ST type
EAS Command 2
Disabled by default, default type: NXP Command, also
optional: FM or ST type
EAS Command 3
Disabled by default, default type: NXP Command, also
optional: FM or ST type
AFI
AFI 1
Enabled by default, default AFI value: 00
AFI 2
…
AFI 4
Enabled: Disabled by default
Default AFI value: 00
Memory
Bank
Option
Memory area
None: Do not read data from UID and USER area
UID area: only read tag UID area (default setting)
USER area: only read tag USER area
UID and USER area: read UID and USER area
User
Area
Start Pos
Offset byte of the barcode data in the data block, the
default value is 0x00
Length
The length of the barcode data, the default value is 16
Unrecogniza
ble Tag
Data block length: the number of bytes in each block,
NXP ICODE SLI series chips are 4 bytes per block.
Read command: For unrecognized tags, we do not know
whether it supports read single block and read multiple
block instructions. If both are supported, then select read
multiple blocks.
Acousto-o
ptic Alarm
Trigger condition
Can be set to trigger an alarm under the following
conditions:
1. None - No sound and light alarm is triggered, and the
alarm is triggered by an external command.
2. Alarm when books are detected - Alarm when a book is