User's Manual

User Manual
Andea Electronics http://www.gzandea.com 1/44
1 Notice before Use
 There should not be strong mechanical driving equipment around the
installation position of the RFID library gate, such as transformers and
generators. These equipment can generate noise and affect the normal
performance of the antenna.
 Determine the independence of each gate and do not allow other cables to
touch the gate, such as power lines, power supply lines and signal lines of
other systems.
 There must be no other equipment of the same frequency (13.56MHz) around
the gate.
 When plugging and unplugging the connection wires of the gate, the gate
must be powered off firstly, please do not plug and unplug the terminal on the
gate with power to avoid damaging.
 Make sure that the gates are placed and wired correctly before powering on.
When installing the gates, pay attention to the orientation of the gate
equipment box, all facing the same direction (the side with the status indicator
should face the same direction and the inconsistent orientation is prohibited).