User's Manual
User manual
Guangzhou Andea Electronics Technology Co., Ltd. 30/39
http://www.gzandea.com
① Reverse UID: the sequence number contained in the data packet of the
inventory command is reversed;
② Enable buffer mode: If checked, the buffer mode is used; if not checked, the
asynchronous output mode is used.
Buffer mode:buffer the read tags in the memory of the reader, and output
them after the inventory is finished.
Asynchronous output mode: it will be output a data packet with a serial
number when a tag is read every time, the end package is output after the
inventory is completed.
③ Reset RF power:
Whether to reset the RF power before the inventory command. If it is not reset,
then the next inventory will not be able to inventory to the dormant tag.
④ Antenna ID as unique identifier: this parameter only applies to buffer mode.
For example: the tag E00405FF11223344 was read by antennas 1, 2 and 3:
Antenna ID as unique identifier:
Table 7 Example of inventory when setting antenna number as unique identifier
No.
Antenna ID
Tag ID
1
1
E00405FF11223344
2
2
E00405FF11223344
3
3
E00405FF11223344
Antenna ID is not used as unique identifier:
Table 8 Example of inventory when setting antenna number not used as unique identifier
No.
Antenna ID
Tag ID
1
E00405FF11223344
⑤ Data field select:
Tag type: whether the tag Data field contains the tag type field .
UID: whether the tag Data field contains the tag UID.
RSSI_V: whether the tag Data field contains RSSI field .
Antenna ID: whether the tag Data field contains antenna ID.
Read count: whether the tag Data field contains this field.