User's Manual

User manual for Wired bluetooth headset T50

Page 1 of 3

1.Introduction

1.3Bluetooth 5.0

1.3.1 Pairing:

1.3.1.1 Press and hold for 3 seconds to turn headset on. [The red and blue indicator lights flash

alternately,accompanied by a long beep]; if there are no other Bluetooth devices connected in 10

minutes, the headset will enter standby mode and the current is 11±2mA; if the product has already

found another Bluetooth device in 10 minutes, click the device to pair. When the product get into

connecting mode,you will hear a short beep and see the blue indicator lights flash continuously for 6

times; the product will be successfully connect after 3 seconds with a long beep.

1.3.2.2、The product will reconnect with the latest paired Bluetooth device automatically in 3 seconds at

distances within 10m. (Please connect the Bluetooth device manually when it is not available to

connect automatically, but there is no need to enter searching interface again).

FCC ID: 2AVBU-T50

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable

condition without restriction.

PAGE 1
User manual for Wired bluetooth headset T50 1.Introduction 1.3Bluetooth 5.0 1.3.1 Pairing: 1.3.1.1 Press and hold for 3 seconds to turn headset on. [The red and blue indicator lights flash alternately,accompanied by a long beep]; if there are no other Bluetooth devices connected in 10 minutes, the headset will enter standby mode and the current is 11±2mA; if the product has already found another Bluetooth device in 10 minutes, click the device to pair.
PAGE 2
User manual for Wired bluetooth headset T50 —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. 1.3.3Play music: 1.3.3.1When the mobile player is paused, short press to revoke the Bluetooth device and enjoy music in high quality stereo. 1.3.3.
PAGE 3
User manual for Wired bluetooth headset T50 1.4.2Maintenance and cleaning: 1.4.2.1 Do not disassemble any parts of the product. If you find the headset problematic, please stop using it. 1.4.2.2Wipe the surface of the headset regularly with neutral soapy water, and dry it with a cotton cloth to keep clean. 1.4.2.3 Do not soak the product in water. 1.4.2.4 Do not wipe the product with chemicals such as banana oil etc..