User's Manual

User manual for Wired bluetooth headset T50
Page 2 of 3
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
1.3.3Play music:
1.3.3.1When the mobile player is paused, short press to revoke the Bluetooth device and enjoy music in
high quality stereo.
1.3.3.2 Short press again to pause the music player.
1.3.3.3If a phone calling in when you are playing music (Bluetooth phone is needed), the product will
turn to dial interface. Short press to answer phone call and short press again to hang up (same
operation during a call) and the product will turn back to music player automatically in 2 seconds
after hanging up.
1.3.4 Phone call
1.3.4.1 When connected, short press the button twice continuously to enter dial interface.(Call back the
last number) ;
1.3.4.2 Short press the button for 3 times to enter voice dialing interface( mobile support required);
1.3.4.3When a phone calling in, short press the button to answer and short press again to hang up (same
operation during a call).
1.3.5Button functions:
1.3.5.1 Previous song: press “-” and hold for 2 seconds, the player turns to last song.
1.3.5.2 Next song:press“+” and hold for 2 seconds, the player skips to next song.
1.3.5.3 Volume up:press“+” to increase volume (long press to continuously increase the volume). When
the volume is increased to the maximum, the product will pause the music with two beep until
release.
1.3.5.4 Volume down: press”-” to decrease volume (long press to continuously decrease the volume).
When the volume isdecreased to the minimum, the product will pause the music with two beeps until
release.
1.3.6Charging and low power prompt function:
1.3.6.1When the battery power is lower than 3.2V,there are three beeps in the product.The beeps will
ring once for every 3 minutes if the product was not yet charging after the prompt tone appears.
1.3.6.2When the battery voltage is lower than 3.0V, the product will shutdown.
1.3.6.3Please charge the battery in time when the battery is low;
1.3.6.3.1Use micor5pinusb data cable to connect DC5V power supply, and charge Bluetooth headset
with 230 ± 10mA current;
1.3.6.3.2During charging, the red indicator light is always on;
1.3.6.3.3The battery is fully charged for about two hours, and the red indicator light goes out.
1.4 Attentions:
1.4.1 It is essential to wear correctly: this will influence the listening experiences which including effect
of noises suppression.