User's Manual

4
3
1.2 2.4G BINDING
R/C Introduction Manual
R/C Introduction Manual
BINDBIND
1. The Binding processing
Turn on the transmitter, then connect the power of receiver keeping the receiver "BIND"
button till the light turn on GREEN which means the binding is successful. After that, it's
unnecessary to bind again.
Caution: making sure that the RX and TX within one meter, and around 10 meters no
similar device.
If the light flashing, showing the binding failure, please do again as above indication.
2.1 Characteristics of system
F u n c t i o n 1 0 . 2 V F u n c t i o n 1 0 . 2 V
1 : E P A
2 : D / R
3 : S _ T R I M
4 : R E V
--3 channels End Point Adjustment
--Support dual rate function for the STEERING
--Sub-trim for THROTTLE channel and STEERING channel
--Model names can use up to 5 letters and numbers, so that easily understood names
can be set. A model memory with different fine setups can be created by using the model
copy function. Sixteen models can be added .
--Brake mixing for large cars (BRAKE)
Brake mixing of the front and rear wheels of 1/5GP and other large cars can be adjusted
independently.
--Anti-skid braking system (A.B.S)
This function applies the brakes so that the tires of gasoline engine cars, etc. do not
lose their grip on the road even when braking at corners.
--SPEED
TH-SPEED：Sudden trigger operation on a slippery road surface will only cause the
tires to spin and the model to not accelerate smoothly. By setting the throttle speed
function, operation can be performed smoothly and easily. It also suppresses battery
consumption.
ST-SPEED：
When you sense that the steering servo is too fast, etc., the servo operating speed
(direction that suppresses the maximum speed) can be adjusted.
--Auto-Start function (ATS)：
A pre-set throttle position, less than full throttle, to be used for the initial acceleration off
the line without having wheel spin. When the trigger is released, auto-start is turned off
and throttle operates normally again.
--Racing timer (TIMER)
The N-4Q has two timers:Down_Timer and UP_Timer.
--Digital trim function
The current trim position is displayed on the LCD screen.
F u n c t i o n 1 0 . 2 V F u n c t i o n 1 0 . 2 V
5 : S T C U R V
6 : T H C U R V
7 : A B S
8 : M O D E L
F u n c t i o n 1 0 . 2 V F u n c t i o n 1 0 . 2 V
1 3 : M I X
1 4 : T H H O L D
1 5 : F / S
1 6 : N E U T R A L
F u n c t i o n 1 0 . 2 V F u n c t i o n 1 0 . 2 V
1 7 : S O U N D
1 8 : R E S E T
1 9 : M _ R E S
2 0 : T I M E R
F u n c t i o n 1 0 . 2 V F u n c t i o n 1 0 . 2 V
9 : S P E E D
1 0 : A T S
1 1 : M O D U L A T E
1 2 : B R _ M I X