User's Manual

3.0 功能说明
3.1 Front panel view
3.2 Rear view
3.3 Wiring diagram and binding procedure
Aileron servo
Rudder servo
Throttle servo
Elevator servo
Power
Undercarriage servo
Flap servo
3.4 Function keys in panel
There are 3funcfion keys on the H-6 panel, Details below:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
1. Antenna
2. Handle
3. Helicopter mode: IDLE (0/1)
mode: CH5 Flap (0/1)
4. D/R (Aile Elve Rudd)
5. LED
6. Left stick
7.
8.
9. Eyelet
10. Power
11. LCD
12. Throttle hold
( mode: CH6 Undercarriage)
13. Right stick
14.
15
16. UP
17. DOWN
18. SELECT
Airplane
Digital trim
Digital trim
Airplane
Digital trim
Digital trim
1
2
3
4
5
6
1.
2.
3.
4.
5. Trainer port/DSC
6. Battery case cover
Screw 1
Screw 2
Screw 3
Screw 4
Binding:
Switch on the transmitter, reduce throttle to its lowest position and make sure the
alarm is off when powering on the receiver/aircraft. Press the bind button (if applicable)
until the green light turns, solid, signaling binding success.
Caution:
While binding, place the transmitter and receiver antennas in close proximity if possible;
make sure that there are no similar devices on bind mode within approximately 10 meters.
If the light flashes after the binding procedure is complete, retry the binding procedure
again until the light turns solid.
UP
DOWN
SELECT
H-6Q Instruction Manual H-6Q Instruction Manual
4
5