User's Manual

Unit Conversion
Button
成品尺寸：92*92mm，展开尺寸：366*92mm，材质：100g铜版纸，4折页，风琴折，双面单黑印刷_20200423
SCALE
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference , and (2) this device must
accept any interference received,including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
The users manual or instruction manual for an intentional or unintentional radiator
shall caution the user that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment. In
cases where the manual is provided only in a form other than paper, such as on a
computer disk or over the Internet, the information required by this section may be
included in the manual in that alternative form, provided the user can reasonably be
expected to have the capability to access information in that form.
SCALE
scale with damp cloth.
p
Scale
Don't
No user information is issued, and no user is identified（Turn on the
Bluetooth of the mobile phone, use the mobile APP to establish a
connection with the scale, and then measure again.）
Multiple users identified in offline testing（During the offline test, the
scale recognizes multiple users by weight, and cannot recognize a specific
user parameter. Please connect to APP directly for online test）
Questions?
Contact Health
855-633-5600
SMART BODY SCALE
INSERTING THE BATTERIES:
Turn the scale over and place it on a flat surface.
Open the battery cover and insert four AAA batteries.
Make sure the positive and negative ends are facing the correct polarity directions
marked in the battery compartment.
Close the battery cover and wait until the digits "0.0" are shown on the LED display.
BATTERY REPLACEMENT:
In the event that the scale batteries need to be replaced (display shows “Lo”),remove
the battery cover.Replace the old batteries with 4 new AAA alkaline batteries. Clean
the battery contacts and also those of the device prior to battery installation. Ensure
the batteries are installed correctly with regard to polarity,and the supply terminals
are not to be short-circuited,then replace the battery cover again. Remove used
batteries promptly. Dispose of the old batteries as per legal regulations. Do not
attempt to open the scale or to remove any components. Servicing should be done
by qualified technicians only.