Quick Setup Guide
Remove the faceplate from the Night Owl Doorbell. Insert the small end of the
provided USB cable into the micro USB port on the doorbell.
Connect the other end of the cable to a USB power adapter and plug it into an outlet.
If you do not have a USB power adapter, you may use a USB charging port.
Be patient for a minute or two as the doorbell powers up. Listen for the audio message
“Doorbell is in pairing mode.” “PAIRING MODE” status is also identied by white LEDs
“Spinning” in a “Clockwise” direction.
3
Doorbell is in
pairing mode.
Note: Use a at tool to carefully remove the cover from the micro USB input. You must replace the cover before
mounting the doorbell.
Note: USB Power Adapter not included.
5
4
5
QSG-WDB20.indd 6 2018/12/14 16:36