Safety Guide

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
FCC Radiation Exposure Statement
Q: How long can the product be stored?
A: It can be stored for 6 months when fully charged. It is recommended to charge it every three months.
General Questions And Answers
Q: Does the product have temperature protection?
A: When the internal temperature is higher than 55 ℃ during charging, it will be protected; when the internal temperature is
higher than 60 ℃ during discharging, it will be protected.
Q: How long does it take for the product to be fully charged?
A: Charge from 3% to 90% with the original adapter for about 6 hours, and it can be fully charged in about 9 hours.
Q: Can you charge the product with DC charging port and usb-c port at the same time?
A: It can be charged at the same time, and the charging time will be shortened.
Q: Can the product be used while charging?
A: It can be used while charging. When the output power is greater than the charging power, the battery power will be reduced.
When it is reduced to a low power state, the output will be turned off.
Q: Will the product shut down automatically?
A: It will not shut down automatically until it is fully discharged. Under normal circumstances, it will not shut down automatically
after power on.
Q: Can the product be used to start the car?
A: It cannot be directly used to start the car. However, another charging line can be selected to charge the starting battery of the car.
When the power of the product is ≥ 20%, the car can be started after charging for 5-10 minutes.
Q: After being fully charged, the power percentage and Fu are not displayed synchronously or have errors. Is it normal?
A: Normal image: "Fu" will be displayed when fully charged, but the power percentage may be 99%.
This device complies with Part 18 of the FCC Rules.
Refer to FCC Part 18.213(c)and KDB 784748 Anner A section A.5:
(a)Max.Electric Field Emissions:5.37V/m Max. Magnetic Field Emissions:0.43V/m
(b) The maintenance of the system is the responsibility of the manufacturer.
(c) To prevent interference, the product should be as far away from devices operating at the same frequency as possible.
FCC Warning