Instruction Manual

Switching Machine Operation
Power On:
Step 1: Press the power button on the body or the power button on the
remote control, the indicator light will turn blue and steady.
Step 2: After 2 seconds, the projector starts to start, the image appears on
the screen, and the unit enters the normal working state.
Step3 : If the projector is newly installed, the image may be blurred or
trapezoidal distortion when it is turned on for the first time. Please refer to
the “Focus/Keystone Correction” section for calibration.
Step 4: After the image is adjusted clearly, it can be viewed normally.
Power Off:
Step 1: In the working state, press the power button of the body or the
power button on the remote control to switch the projector to the standby state.
Step 2: After the projector enters the standby state, the machine is in the
process of automatic heat dissipation, and the indicator light changes from
blue to red.
Connect the power cord to the projector before connecting the power cord to an
electrical outlet.
- 6 -
Power Key
Power Indicator