Specifications

SKI.W7603.1

QR-ZZPJ-017A

版权 CVTE 所有，本文档内容属商业机密。未经允许，任何组织或个人不得以任何形式复制和传播。

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two

conditions:

(1) this device may not cause harmful interference, and (2) this device must

accept any interference

received, including interference that may cause undesired operation.

Caution: The user is cautioned that changes or modifications not expressly

approved by the party

responsible for compliance could void the user's authority to operate the

equipment.

Note: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

a minimum distance of 20cm between the radiator and any part of your body.

The device must be professionally installed

The intended use is generally not for the general public. It is generally for

industry/commercial use.

The connector is within the transmitter enclosure and can only be accessed by

disassembly of the transmitter that is not normally required. the user has no access

to the connector.

Installation must be controlled. Installation requires special training

This module has been assessed against the following FCC rule

parts: CFR 47 FCC Part 15 C (15.247, DTS). It is applicable to the

modular transmitter