User's Manual

z Please do not arbitrarily change the emission frequency, increase the transmission power (including

add RF power amplifier), add external antenna or use other transmit antennas;

z Please do not make interference to legitimate radio communication services during the using of

product. Once the interference occurs, user should immediately stop using the product and the product

should not be used unless the interference is disappeared;

Installation Instructions

z The vehicle must meet the voltage, current and power that required, please check the conditions

before installation;

z The installation should be done while the battery of the vehicle is disconnected;

z To ensure that the product has been fitted with a fuse;

z The installation of the product should not affect the safety of the operation and function of the

vehicle;

z The installation position should not block the driver's sight and should not be on the place that the

brake, steering wheel, seat belts, airbags and other vehicle safety equipment should be;

z Please confirm the matching condition of the vehicle interface before install this product, use the

appropriate patch plug if the interface is not matched;

z Please be familiar with the connection of the vehicle before installation, confirm the position of

the piping, electrical wiring, fuel tank and other vehicle system components. Do not touch or damage

these components and avoid the exposure of wires that may cause corrosion, leakage, etc.;

z Please do not conduct the installation in place of condensation, drench water sites, high humidity,

containing dust and oil smoke. If water, moisture, dust and oil smoke enter the product, it may cause

smoke, fire or failure;

z Please do not move or disassembled the existing screws, nuts, bolts, clips, connecting fixed

appliances, accessories and so on, do not change or remove vehicle incidental contact system and wire

clip, otherwise it may impair the function of automobile safety;

z In order to avoid the occurrence of fire damage to the product or vehicle, please do not allow the

existing power supply circuit overload when power the product; Please be sure that the power wires

have insulation treatment and install with fuses, circuit breakers and relays;

z Please use nonconductive tape in insulation treatment, wrap the ends of the wire and unused wire;

correct insulating treatment can avoid the occurrence of electric arc, electric shock or fire. In order not to

impede the brake pedal, gearbox and steering wheel, plastic belt could be used to fix the wires. Please do

not make the wires contact high temperature surface, the heat can easily cause damage to the wires and

lead to short circuit, arc or fire;

z Please fix the wire on the electric chair or other parts of vehicle where will not lead to the

scratch or damage of wire. In addition, the wire should be fixed in the hidden place as far as

possible, it will make the environment inside the vehicle beautiful;

z Please do not block the airflow vents, otherwise it may cause internal overheat and fire;

z After the installation is completed, please check the wire connection of the vehicle, then run all

functions, including lights, speakers, stereo, reversing operation and other electrical systems and ensure

that the vehicle function is normal and can be used safely.